86-15268886333

News

Home / News / Industry News / How to slot the water p低男ipe installation?

How to slot the water pipe 美請installation?



After the water is heated by the water知媽 heater, it is now circul吧離ated to the vegetable bas煙睡in, wash basin, and shower, a金會nd there is a phenomenon that t門腦he water is not hot. Many people ar一他e confused and say that there is a p物聽roblem with the water he嗎議ater, the water heate湖說r maintenance worker said tha話長t the pressure of th們資e gas is low, and so on. In fact, every業下one has overlooked a p離員roblem, that is, there is a problem i購喝n the installation process of the water理畫 pipe.

In the process of installing th視作e water pipe, it is very be物下autiful to slot the water pipe 多文in the wall and bury the water pi民熱pe in the wall, but som微為e installers do not want to open the拍文 wall groove too wide in orde醫見r to save effort, especially whe少為n there are many reinforced conc亮線rete walls, the slotting is quite It i年媽s difficult, so if you c筆區an make less grooves, you can m議筆ake less grooves, and squeez樹對e the hot and cold water pipes tigh從笑tly. It is not right for the hot a年畫nd cold water pipes to be close to日兒gether. After the test, the two 不跳water pipes are close to each othe雜離r for 20 meters, and the hot and cold爸筆 water are in a circulating state.紅間 The temperature of 街生the water outlet from the water he錢媽ater is 80 degrees to 70 degrees at the快一 end, and 55 degrees at t師影he end 10 minutes before the畫鄉 start.

When the hot and cold water pipes are從路 separated, its temperature is 80-78 d厭上egrees. This test is very 拿問telling. Take a water pipe wit得讀h a diameter of 20 (usually refers業做 to a four-point pipe) and the gr可雪oove should be (upper end 1CM + hot玩房 water pipe 2CM + mi鐘學ddle distance 2CM + cold water pip風火e 2CM + lower end 1CM) a t老行otal of 8CM The distance b生師etween the two water pipes 有紙should be at least not 費們less than 2CM.